Oxy-fuel motorized cutting head

Characteristics Oxy-fuel motorized cutting head

  • highly technically equipped carrier of the torch and additional equipment for autogenic cutting
  • the construction prevents damage of individual parts of the cutting head caused by impact and enables their re-set and further running of the cutting machine
  • 'floating' construction of the head enables protection of the torch against collision maintaining constant distance above the surface of the cut material
  • backflash-free attachment of guiding elements
  • can be used for all types of manufactured autogenous cutting machines
  • maintance-free construction
  • the machine torch is a part of the cutting heads

Technical data

  • dimensions: 100mm x 95mm x 470mm,
    120mm x 95mm x 470mm
    (width x depth x height)
  • torch diameter: 32mm (resp. 30mm)
  • travelling speed: 2100mm/min
  • range of vertical movement: 150mm
  • incoming supply: 24V DC
  • axis setting: sagittal angle 45°, right-left angle 45° 

 

Carrier of the oxygen torch and equipment
  • dimensions: 100mm x 95mm x 470mm, 120mm x 95mm x 470mmCarrier
    (width x depth x height) 
  • travelling speed: 2100mm/min
  • range of vertical movement: 130mm 

The torch holder for torch dimension 32 mm (resp. 30 mm)

Enables manual setting the angle and position of the torch.

Torch holderTorch holder

Torch holder

 

Automatic ignition

The automatic ignition is meant for igniting the torch. It is made ofAutomatic ignition:

  • high-voltage coils ZAG 15F
  • solenoid valve for turning the gas on
  • brass mixing body
  • ignition plug

Capacitive material distance sensor

The capacitive height lookout is meant for contactless height watching of the torch above the material while the cutting process is in progress. It is made of:

  • control card 2001 - 6A (it cooperates with the head card 2001 - 7A) Capacitive material distance sensor
  • RF cable with connectors
  • holder of the capacitive ring (the teflon part consisting of two elements enables swing of the ring to the side in case of touching the material – sudden tilting of the workpiece)
  • capacitive ring

Solenoid valve (3 pieces)

Solenoid valve

The solenoid valve is meant for turning on the preheat gas, preheat oxygen and cutting oxygen. Operating voltage is 24 V DC. Diameters of mouthpieces for connecting hoses: preheat gas 8 mm, preheat oxygen 8 mm, cutting oxygen 10 mm, torch ignition 6mm.

 

The machine torch is a part of the cutting heads HARRIS
1982Tc

Automatic engine control

Electronic head card 2001 - 7A enables controlling DC motor that controls the movement of the torch in vertical axis.


News

02.05.2016

EUROBLECH 2016 - Hannover, Germany

Dear customers, we would like to invite at the world's largest trade fair for sheet metal working industry, which will take place from 25 October 2016 to 29 October 2016 at the Exhibition Grounds in Hanover, Germany.
More »